![]() The zip file containing all of these files is what needs to be sent to the manufacturer. Make sure you zip up the NC Drill files with the Gerber files, or the mechanical board holes will not be drilled. The first part is the Altium extension for the file, the second is the layer the file describes. The following files are required for board manufacturing. This does not need to be sent to the manufacturer. The default settings also have the box checked for “Generate DRC Rules export file (.RUL)”. This can easily be done by clicking “Plot Layers” -> “Used on”. All the files with relevant information for the board need to be created. On both pages the files to be created are shown. On the right side there are 2 tabs, “Layers To Plot” and “Drills”. Increasing the precision may increase the price of the board, but that has never actually been tested. This is the recommended option for boards with high density parts, such as an FPGA or an FMC connector. The “Format” lists the decimal precision to be outputted, with 2:6 being the most precise. ![]() Once this is open, there are several settings that are ok to change. Gerber and drill files can also be created separately if needed. This will allow you to create the gerber as well as the drill files at the same time. (More about stencils below)įrom the PCB document, click File -> Fabrication Outputs -> Gerber X2 Files. They also contain the files needed to create a board stencil. These are the files that need to be send to the manufacturer. The following gives some general information regarding PCB ordering for the CCL.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |